Ayra Compar 50 RGBAW+UV LED proyector
Light output a little disappointing, especially the UV. However there is a major issue with the firmware and DMX control. If you are using DMX software to control these lights, and you use the Channel 9 operating mode selection to call up a slow colour fade, then it will automatically assume that any other dmx commands issued to it are to be done at that same speed of fade. This means that if you wanted to go to say a fast Red Blue Green jump sequence, then it will not jump between the colours, but fade them. Even if you return the channel 9 dmx to zero, it still does the same. Your only option is to issue a command to CH9 to go to either a fast jump or fast fade, then go to your dmx issued colour changes, and the fade will be gone. The channel 9 should have the 0 value set to cancel out any fades etc associated with the built in effects so that they dont affect the normal DMX operations.
25 de mayo de 2023
|
Jonathan
Esta reseña ha sido traducida automáticamente del inglés.
