- Inicio /
- Catálogo completo /
- Micrófonos /
- Accesorios para micrófonos /
- Soportes y pinzas de micrófono
Soportes y pinzas de micrófono
cado
cado
Con el soporte para micrófono Devine SDH-02 con pinza de micrófono, enganchas en un momento un segundo micrófono a un soporte. Es ideal si usas, por ejemplo, un micrófono para el instrumento y otro para el cante.
cado
Con el Devine SDH-04 conviertes tu soporte de micrófono en uno para dos micrófonos. Montas el soporte en el del micrófono y colocas tu micrófono en la pinza correspondiente. Con cuello de cisne para una colocación flexible.
cado
Es una solución práctica para colocar un micrófono en tu amplificador de guitarra. En un momento montas el soporte de micrófono en tu amplificador de guitarra y eliges la posición adecuada para tu micrófono.
cado
cado
Este Devine SDH-01 es un soporte para montar un segundo micrófono en un soporte trípode. El cuello es flexible y tiene multitud de posiciones.
cado
You can record the sound of your drum kit perfectly with this set of three microphone clips. The DMC100s are easy to place. The height and the angle of the microphone can be adjusted.
cado
cado
This universally useable adapter allows you to optimally position microphones and hand-held recording devices for great recordings.
cado
This black microphone holder is easily attached to stands with a maximum diameter of 23 mm. Subsequently, a goose neck, a mic arm or a mic clip can be attached.
cado
cado
cado
This T-bar allows you to mount two microphones on one mic stand and is therefore a great way to save some positioning space in your setup.
cado
cado
This microphone holder makes amplifying and recording your drums (and your bass drum in particular) much easier. It clings to the rims and has a black coating so it won't stand out on a dark stage.
This microphone T-Bar provides space for a total of four microphones.
This joint allows for optimal manoeuvrability. It is perfect for the end of microphone stands, allowing you to optimally position your microphones so you can make the perfect recording.
If you want to position multiple microphones on one stand, this is the ultimate solution. Whether you want to record an entire choir or provide back up during conferences, this K & M microphone bar really comes in handy.
Never again will you have to screw or unscrew microphones when you often swap them. This practical product uniforms the coupling and can be attached or detached with a single hand. Perfect for stage and studio.
The Sennheiser MZH 908 D clamp is specifically designed to fasten the Sennheiser E 908 microphone or the Sennheiser E 608 microphone to a drum.
The Sennheiser MZT 30 L is a flush mount for your Sennheiser gooseneck with 5-pin XLR connector: MZH 3015 L, MZH 3040 L and MZH 3042 L. By drilling a hole of 24 mm in your table, lectern or other surface, you can perfectly flush-mount the MZT 30 L in the surface.
