basado en 3036 reseñas

Palmer DACCAPO reamp box

No disponible, este producto ya no puede adquirirse.

Artículos alternativos
Palmer DACCAPO reamp box
nº de producto: 9000-0048-1414

Información del producto

General

As a reamp box, the Palmer DACCAPO is a special little bit of kit designed to play a pre-recorded DI signal through a guitar amplifier. Effortlessly change up your tone by placing the virtual microphone near the speaker cabinet, changing the amp settings, or even swapping it out for a different one. And, if the signal isn't loud enough, you turn up the volume control or flick the attenuation switch, while the fitted ground/lift switch takes care of any unwanted signal hum. Simply run an XLR cable from your recording condole to the DACCAPO, then jack another into your amp, and you're good to go.

Garantía Bax Music El periodo de garantía de este producto es de 2 años.

Características

Características del producto

Sustainable product
Not specified

Peso y las dimensiones incluyen el paquete

Peso
500 gr
Dimensiones
14,0 x 9,0 x 5,5 cm

Características del producto

  • Palmer DACCAPO
  • reamp box
  • converts a pre-recorded line signal for an amplifier
  • connectors:
    • XLR in
    • jack out (isolated)
  • level knob
  • ground lift
  • -10 dBV/+4 dBu switch
  • dimensions: 80 x 125 x 45 mm
  • weight: 507g

Vídeos

5,0
1 valoración

Valoración

5 estrellas 1 4 estrellas 0 3 estrellas 0 2 estrellas 0 1 estrella 0
Ya no se puede escribir una opinión sobre este artículo

Reseñas de otros países

5 / 5

Palmer DACCAPO reamp box

Doet wat het moet doen. Klinkt even goed als een Radial Reamp. Dank u Bax!
 | 
Esta reseña ha sido traducida automáticamente del holandés.