Audio Technica ATM350W

Audio Technica ATM350W
nº de producto: 9000-0030-1901

Información del producto

General

Audio Technica's ATM350W consists of the enhanced ATM350a condenser microphone and the AT8491W woodwind mounting system. The latter features a 12.7cm gooseneck for optimal positioning. The UniMount system allows you to use the microphone with a large number of different instruments, even though the ATM350W is especially developed for wind instruments. The condenser mic can handle a very high sound pressure level, making it suitable for instruments with broad dynamic ranges.

Focused audio thanks to cardioid pickup pattern

The ATM350a's audio remains focused and clear at all times thanks to its cardioid pickup pattern. Any sound from the sides or behind the mic are filtered out, resulting in a pure representation of the audio source. There is also an 80Hz high-pass filter on the microphone that filters out low frequencies and noise when activated. Finally, the gooseneck is made of a durable material that is both robust and flexible, allowing easy and optimal positioning in seconds.

Características

Características del producto

Conexión de la petaca: XLR 3p
Sensibilidad micrófono (dBV/PA): -49
SPL máxima: 150 dB - 159 dB
Frecuencia máxima: 20 - 20.9 kHz
Frecuencia mínima: 40 - 49 Hz
Patrón de captura: Cardioide
Especial para: Instrumento de viento, contrabajo, caja / tom /percusión, piano

Peso y las dimensiones incluyen el paquete

Peso: 739 gr
Dimensiones: 31,5 x 15,0 x 8,5 cm

Características del producto

instrument microphone
capsule: condenser (permanently polarized)
pickup pattern: cardioid
frequency response: 40 - 20,000 Hz
high-pass filter: 80 Hz, 12 dB
sensitivity: -49 dB (3.5 mV) 1V @ 1 Pa
impedance: 200 ohms
max. sound pressure level (SPL): 159 dB, 1 kHz @ 1% THV
dynamic range: 130 dB, 1 kHz @ max. SPL
signal-to-noise ratio: 65 dB, 1 kHz @ 1 Pa
phantom power supply: 11 - 52V / 3.5 mA
switch: neutral, roll-off
mic weight: 14.5 g
power module weight: 90 g
microphone dimensions:
- 37.8 mm (length)
- max. body diameter: 12.2 mm
- power module dimensions:
- 92 mm (length)
- 18.9 mm (diameter)
output connector: 3-pin male XLR
cable:
- length: 4 m (permanently attached to microphone)
- diameter: 3.2 mm
- type: HIROSE HR10 (shielded)
box contents:
- ATM350a cardioid condenser microphone
- AT8543 power module
- AT8491W woodwind mounting system
- AT8490 UniMount 5-inch gooseneck
- AT8468 violin clip
- M36 protective carrying bag