General
The Elation Cuepix Blinder WW2 is a proper quality Blinder that brings all the advantages of LED technology: low energy consumption, a long lifespan and limited heat emission. As it uses COB (Chip-on-Board) LEDs, the Cuepix Blinder WW2 gives off a nicely even light image, and your TV/film recordings won't be bothered by flickering flashes. Two warm white (3,200K) COB LEDs - with 100 watts of power each and an enormous light output - achieve blindingly wonderful effects!
Operating modes of the Cuepix Blinder WW2
You can easily set an operating mode via the four control buttons and LED screen which are at the rear of the blinder, or you can use RDM (Remote Device Management). The unit features a Stand Alone mode with Master/Slave-compatibility, and can also be operated via DMX over 1, 2, 3 or 4 channels. If you're using four DMX channels, you can individually control each COB module for a versatile effect.
Setting up and monitoring
The blinder is fitted with 3-pin as well as 5-pin DMX inputs and outputs, allowing you to easily daisy chain multiple blinders. The same goes for power, which is provided via Neutrik PowerCON connectors. The Elation Cuepix Blinder WW2 features an integrated rigging bracket, with which you can suspend the light effect, or put it in an upright position.
