basado en 3036 reseñas

DAP Palladium P-500 Black Series amplificador PA

aún no hay comentarios
DAP Palladium P-500 Black Series amplificador PA

No disponible

Este producto ya no puede adquirirse

Características

Características del producto

Formato rack 19
Sí, 2 U
Compatibilidad 2 Ohm
No
Number of amplifier channels
2
Salida bucle de audio
No
Modo puente
Sí
Conector de entrada
Jack de 6,35 mm, XLR
Filtro
Ninguno
Protecciones
Sobrecarga, térmica, cortocircuito, voltaje DC, indicador clip
Procesador DSP
No
Refrigeración
Ventilador
RMS power (4 ohms) per channel
250 - 299 watts
RMS power (at 8 Ohms) per channel
150 - 199 Watts
Tipo de ampli
AB
Salida de ampli
Speakerconnector, pinza
Provisto de crossover
No

Peso y las dimensiones incluyen el paquete

Peso
16,5 kg
Dimensiones
60,0 x 60,0 x 20,0 cm

Características del producto

  • powerful Class AB stereo PA amplifier
  • colour: black
  • affordable and reliable
  • XLR and jack inputs
  • lockable speaker connectors and wire clamp outputs
  • power stereo: 2x 180 watts RMS at 8 ohms, 2x 270 watts RMS at 4 ohms
  • power bridged: 540 watts RMS at 8 ohms
  • frequency range: 20 Hz to 45 kHz, -1 dB
  • THD+N < 0.05%
  • intermodular distortion < 0.01%
  • damping factor (8 ohms) > 250
  • slew rate > 40V/ µS
  • input CMRR > 60 dB
  • crosstalk 20 - 20,000 Hz > 60 dB
  • signal/noise ratio: 105 dB (A-weighted)
  • input sensitivity: 1V~, +2.2 dBu
  • maximum input voltage: +22 dBu
  • input impedance: 20 kOhm balanced, 10 kOhm unbalanced
  • security: temperature, short-circuiting, DC voltage, subsonic, high frequency, on/off
  • output modes: stereo, parallel, bridged
  • cooling: two DC fans with two speeds
  • air stream: front to back
  • inputs per channel: 1x XLR female (pin 2 +), 1x TRS jack (tip +)
  • outputs per channel: 1x lockable connector 2x wire clamp (+ and -)
  • ground lift switch available
  • power supply: 200 - 240 V~, 50Hz
  • power consumption (2x 4 ohms): 850 watts
  • controls: front 2x volume control, read ground lift jumper
  • LED indicators per channel, protect, clip, signal, power
  • fuse: 6.3AT, 5 x 20 mm
  • dimensions: 483 x 430 x 89 mm (LxWxH)
  • weight: 11.8 kg

No se han encontrado alternativas

Características

Características del producto

Formato rack 19
Sí, 2 U
Compatibilidad 2 Ohm
No
Number of amplifier channels
2
Salida bucle de audio
No
Modo puente
Sí
Conector de entrada
Jack de 6,35 mm, XLR
Filtro
Ninguno
Protecciones
Sobrecarga, térmica, cortocircuito, voltaje DC, indicador clip
Procesador DSP
No
Refrigeración
Ventilador
RMS power (4 ohms) per channel
250 - 299 watts
RMS power (at 8 Ohms) per channel
150 - 199 Watts
Tipo de ampli
AB
Salida de ampli
Speakerconnector, pinza
Provisto de crossover
No

Peso y las dimensiones incluyen el paquete

Peso
16,5 kg
Dimensiones
60,0 x 60,0 x 20,0 cm

Características del producto

  • powerful Class AB stereo PA amplifier
  • colour: black
  • affordable and reliable
  • XLR and jack inputs
  • lockable speaker connectors and wire clamp outputs
  • power stereo: 2x 180 watts RMS at 8 ohms, 2x 270 watts RMS at 4 ohms
  • power bridged: 540 watts RMS at 8 ohms
  • frequency range: 20 Hz to 45 kHz, -1 dB
  • THD+N < 0.05%
  • intermodular distortion < 0.01%
  • damping factor (8 ohms) > 250
  • slew rate > 40V/ µS
  • input CMRR > 60 dB
  • crosstalk 20 - 20,000 Hz > 60 dB
  • signal/noise ratio: 105 dB (A-weighted)
  • input sensitivity: 1V~, +2.2 dBu
  • maximum input voltage: +22 dBu
  • input impedance: 20 kOhm balanced, 10 kOhm unbalanced
  • security: temperature, short-circuiting, DC voltage, subsonic, high frequency, on/off
  • output modes: stereo, parallel, bridged
  • cooling: two DC fans with two speeds
  • air stream: front to back
  • inputs per channel: 1x XLR female (pin 2 +), 1x TRS jack (tip +)
  • outputs per channel: 1x lockable connector 2x wire clamp (+ and -)
  • ground lift switch available
  • power supply: 200 - 240 V~, 50Hz
  • power consumption (2x 4 ohms): 850 watts
  • controls: front 2x volume control, read ground lift jumper
  • LED indicators per channel, protect, clip, signal, power
  • fuse: 6.3AT, 5 x 20 mm
  • dimensions: 483 x 430 x 89 mm (LxWxH)
  • weight: 11.8 kg

Información del producto

nº de producto: 9000-0004-1135

General

Following the success of the silver Palladium Vintage series amplifiers, DAP Audio decided to release the same series in black. This P-500 from the Black Series Palladium is a powerful class AB stereo PA amplifier with an excellent price/quality ratio. It delivers a power of 2x 180 watts at 8 ohms and 2x 270 watts at 4 ohms. In a bridged capacity, it provides an impressive 540 watts at 8 ohms. This is more than enough for smaller satellite speakers in clubs or mobile PA systems.

P-500 Black Series: built-in security and versatile connectors

The DAP Audio P-500 is provided with built-in safeties, so that you can transfer all its power to your speakers in a safe and reliable way. The unit is equipped with a protection against overloading, a clip limiter and a safety that prevents overheating and short-circuiting. Thanks to the extensive array of connectors, you can connect nearly any sound source or speaker. Both channels of the P-500 are provided with an XLR and a TRS jack input. The outputs per channel consists of a lockable speaker connector and a number of traditional wire clamps.

The proven quality of the Palladium amplifier

Who is not familiar with the DAP Audio Palladium series? Many have grown up around them, many have started their musical career with them and are still working with them. Just like the silver-coloured Vintage Series, the Palladium Black Series consists of seven amplifiers, varying in power from 400 watts to a whopping 2,000 watts! They all have one thing in common: proven quality and an extremely attractive price. All of this comes in a compact 2U, 19-inch rack size.

Garantía Bax Music El periodo de garantía de este producto es de 2 años.

Opiniones

Ya no se puede escribir una opinión sobre este artículo
Aún no hay opiniones sobre este producto.