basado en 3036 reseñas

Behringer NX3000D Amplifier with DSP Processor

No disponible, este producto ya no puede adquirirse.

Behringer NX3000D Amplifier with DSP Processor
nº de producto: 9000-0046-0326 Garantía Bax Music: Este producto tiene una garantía de 3 años (siempre y cuando se registre en la página de Behringer dentro de los 90 días siguientes a su adquisición). Si el producto no se registra, la garantía será de 2 años.

General

The Behringer NX3000D is a lightweight, class-D amplifier with 440 Watts of power at 8 Ohms. This boost box is packed with modern technology, such as Zero-Attack limiters and SmartSense. The limiters ensure trustworthy overload protection at maximum output, while SmartSense offers flat frequency range during impedance. The NX3000D can be used in three modes: mono, stereo or bridge. Bridge mode, combined with a 4 Ohm access port, will net you a dazzling 3000 Watts of power for you to unleash. With a built-in DSP section with delay, crossover and an 8-band parametric equalizer, there's more than enough tools to put all those Watts to good use. Adjust, check or monitor the amp via USB and use the NX Edit software to create your own presets.

Características

Características del producto

Formato rack 19 sí, 2 U
Compatibilidad 2 Ohm no
Number of amplifier channels 2
Salida bucle de audio no
Modo puente
Sustainable product not specified
Conector de entrada jack de 6,35 mm + XLR, USB
Filtro HPF, LPF, bandpass
Protecciones sobrecarga, térmica, cortocircuito, voltaje DC, limiter, indicador clip
Procesador DSP
Refrigeración ventilador
RMS power (4 ohms) per channel not specified
RMS power (at 8 Ohms) per channel not specified
Tipo de ampli D
Salida de ampli speakerconnector
Provisto de crossover no

Peso y las dimensiones incluyen el paquete

Peso (incluyendo el paquete) 4,6 kg
Dimensiones (incluyendo el paquete) 56,0 x 30,5 x 16,8 cm

Características del producto

  • Behringer NX3000D
    • class D amplifier
    • peak power: 2x 440W (8 ohms), 2x 900W (4 Ohms), 2x 1500W (2 Ohms)
    • bridged peak power: 1500W (8 Ohms), 3000W (4 Ohms)
    • frequency range: 20 Hz - 20 kHz
    • THD: <0.05%
    • S/N ratio: >100 dB
    • dampening factor: >145 dB @ 8 Ohms
  • connectors:
    • 2x XLR/TRS combo (input CH A/B)
    • 2x lockable speaker connection (output CH A/B)
    • power cable
  • controls
    • 2x volume (CH A/B)
    • power
    • crossover (LF/bandpass/HF, rear)
    • mode (bridge/stereo/mono)
  • dimensions: 231 x 483 x 94 mm
  • weight: 3.5 kg
Ya no se puede escribir una opinión sobre este artículo

Reseñas de otros países

Traducir todos los comentarios al español

Behringer NX3000D Amplifier with DSP Processor

Escribió lo siguiente sobre Behringer NX3000D Amplifier with DSP Processor
Voor thuisgebruik is het echt aangenaam ! Ik gebruik deze voor mijn subwoofer en de ingebouwde DSP is top kwaliteit. Vrij krachtig voor de prijs en kan subwoofer van 4ohm aansluiten op bridge. De ingebouwde ventilator is vrij hoorbaar maar een fan van 80mm 12VDC 2PINS is makkelijk te vervangen(er is een youtube video over hoe het moet, vrij makkelijk). Top product voor prijs.
Behringer NX3000D Amplifier with DSP Processor

Escribió lo siguiente sobre Behringer NX3000D Amplifier with DSP Processor
Eerste reactie, ieuw een Behringer. Tweede reactie, oeh wat klinkt dat strak. Geen idee natuurlijk hoe lang de versterker het vol gaat houden, maar het geluid icm mijn EV luidsprekers is fantastisch. De ingebouwde dsp kan handig zijn als je mengtafel geen die features niet heeft, of als je een crossover nodig hebt. Versterker heeft 4,5 uur op vol vermogen staan blazen -3dB ledje was semi permanent aan, geen krimp gegeven, apparaat voelde koel aan, en weegt voor de verandering eens geen 35 kilo.



4 sterren vanwege de rumoerige ventilatie.
Descripción Tipo Idioma Extensión
Handleiding Manual neerlandés

Productos similares de otras marcas

Buscar todos los productos en la categoría Amplificadores