▾

SPL Phonitor 2 amplificador para auriculares

No disponible, este producto ya no puede adquirirse.

No se han encontrado alternativas

Información del producto
Opiniones (1)
Descargas (2)

SPL Phonitor 2 amplificador para auriculares
nº de producto: 9000-0009-1911 Garantía Bax Music: El periodo de garantía de este producto es de 2 años.

General

Finally, a worthy monitor sound on your headphones with the Phonitor 2 from SPL. The high-end headphones preamp simulates the exact stereo studio sound on your headphones. You can adjust the centre point, the cross feed and the angle of the speaker. Next to that, the SPL Phonitor 2 can also be used as monitor controller, so you can switch between three audio sources.

Phonitor 2: suitable for every type of headphones

The SPL Phonitor 2 is suitable for every type of headphones with a high impedance sound full and powerful. It is optimized for headphones with an impedance of about 40 ohms. You can use any infrared remote control operate the headphone preamp, making it ideal for audiophiles who want to enjoy their music without getting up from their chair.

Características

Características del producto

Formato rack 19	no
Fuente de alimentación	red
Ecualizador integrado	no
Función talkbak	no

Peso y las dimensiones incluyen el paquete

Peso (incluyendo el paquete)	5,0 kg
Dimensiones (incluyendo el paquete)	54,0 x 38,0 x 19,0 cm

Características del producto

high-end studio headphone amplifier
suitable for all headphone systems and impedances from 10 Ohm
speaker simulation via headphones
monitoring alternative for studios and mobile units
adjustment of centre point and stereo image
large volume knob
built-in monitor controller
adjust volume via remote control (not included)
compensation for difference in panning levels
line inputs: 2x stereo XLR inputs, 1x stereo RCA input
monitor/line output: stereo XLR output
front-mounted headphone output
voltage: 230 V, 50 Hz / 120 V, 60 Hz
energy usage: max. 23.7 VA
fuses (200-240 V): T 630 mA
fuses (100-120 V): T 1 A
dimensions: 12.6 x 4.4 x 13.4" (277 x 305 x 99 mm)
weight: 9.5 lb (4.3 kg)

inputs:

monitor output 1: 2x 3-pin XLR, balanced
monitor output 2: 2x 3-pin XLR, balanced
impedance: 20 kOhm symmetrical, ca. 10 kOhm asymmetrical
maximum input level: : 32.5 dBu
configuration: pin 1 = GND, pin 2 = positive (+), pin 3 = negative (-)
monitor output 3: 2x RCA, unbalanced
configuration: tip = positive, shield = GND

monitor/line outputs:

connector: 2x 3-pin XLR, balanced
frequency range (-3 dB): 4 Hz to 480 kHz
CMR: -82 dBu
crosstalk @ 1 kHz: -106 dB
THD @ 1 kHz: 0.00085 %
dynamic range: 134.37 dB

headphone output:

connector: 1/4" (6.3mm) stereo jack (TRS)
configuration: tip = left, ring = right, sleeve = GND
impedance: 0.18 ohms
frequency range (-3 dB): < 10 Hz tot > 480 kHz
CMR: -106 dBu
crosstalk @ 1 kHz: -106 dB
THD @ 1 kHz: < 0.00091 %
dynamic range: 133.62 dB
max. output level (@ 1 kHz and 600 Ω): 65 mW (20 dBm)
max. output level (@ 1 kHz and 40 Ω): 560 mW (20 dBm)

Ya no se puede escribir una opinión sobre este artículo

Reseñas de otros países

Traducir todos los comentarios al español Mostrar la reseña original

Hugo Z. 7 de enero de 2018

Escribió lo siguiente sobre SPL Phonitor 2 amplificador para auriculares

SPL is echt een geweldig degelijk (Duits) bedrijf. Al hun producten zijn onwijs goed gebouwd en klinken strak. De Phonitor 2 + expansion rack zijn naast de SPL Masterbay mijn basis systemen voor het afluisteren. Ook voor koptelefoon mixen naar mijn inziens de allerbeste oplossing. Niet het goedkoopste maar wel gegarandeerd jaren plezier.. dat verdient zich dus wel terug. De combinatie van de goede service van zowel SPL als Bax-SHop geven dit extra zekerheid.